Hatch Defender™ II Glove W/Steel Shot
The Defender™ II glove features a double-layered goatskin palm for extreme durability and abrasion resistance. Four ounces of steel shot is sewn into each knuckle area. It features the Hatch® Ergo-Cut™ design.
Features :-
The Defender™ II glove is constructed of double-layered goatskin palm for extreme durability and abrasion resistance. Four ounces of steel shot is sewn into each knuckle area and each finger is foam padded for extra protection. They feature the Hatch®® Ergo-Cut™ design for greater dexterity and freedom of movement. Spandex fabric on the back of the hand offers comfort, and the hook and loop closure provides for a snug fit.
Product Care :-
- Hand wash with mild soap
- Do not bleach
- Do not machine dry
- Do not dry clean
- Do not use if damaged
- Do not store in direct sunlight
Size Chart :-
Use one of these methods to find your approximate glove size. Remember, no two hands are alike. Finger length relative to palm size is not constant from person to person. Additionally, what constitutes a comfortable fit can vary considerably between individuals. Using one of the methods below will help you to find an approximate glove size, but no method of measurement can substitute for actually trying them on.
USING A TAPE MEASURE AND THE SIZING GUIDE (MORE ACCURATE)
Wrap a tape measure around your hand at the widest point (usually the knuckles) and make a loose fist. Note that measurement, round it to the nearest inch and refer to the chart above to find your approximate glove size.
The measurement that follows the right side of your hand is your approximate glove size. This is a general guide only.